Single-point quick pipe clamp for fast, tidy fixing of pipes, hoses and conduits in greenhouse structures.
The electrolytically zinc-plated steel body offers reliable everyday corrosion protection, while the compact
one-screw design keeps projections minimal along crop rows. An internal rubber lining cushions vibration, protects
coatings and helps prevent chafing on thin-wall tube.
The snap-close jaw speeds installation and rework: close the clamp around the line and secure with a single screw or bolt
to trusses, purlins or plates. Load is spread evenly across the cushioned contact area, maintaining neat alignment for
irrigation lines, sensor cables and small services. Suitable for new builds and retrofit upgrades.
Key features
Single-point quick fixing: one fastener for rapid installs and easy access.
Electrolytic zinc plating: clean finish and dependable protection in covered greenhouse zones.
Cushioned lining: vibration/noise damping and abrasion protection for pipe and hose.
Low profile: compact geometry reduces snagging and keeps aisles clear.
Even load spread: protects thin-wall tubing and maintains tidy routing.
Greenhouse applications
Irrigation/drip lines, fertiliser feed and misting pipes.
Cable and conduit runs for sensors, screens and control equipment.
Light brackets and guide lines on purlins, trusses and perimeter steel.
Installation guidance
Close the clamp around the pipe; fix with a suitable screw/bolt and washer through the single mounting hole.
Do not over-torque: compress the liner just enough to prevent movement while allowing thermal expansion.
Avoid cutting/grinding near the clamp to preserve the zinc and liner.
Maintenance
Inspect annually for liner wear and fastener condition; re-torque after thermal cycles.
Replace worn nuts/washers and any hardened lining to maintain damping performance.
