The TG-245 is a straight, in-line wire clamp with M10 connection designed for precise routing and anchoring of greenhouse wires. It keeps trellis and crop support lines perfectly centred along bays and rows, ensuring neat alignment on trusses, purlins, lattice beams and perimeter frames. Manufactured from structural steel and finished hot-dip galvanised, the clamp delivers robust corrosion protection against humidity, condensation and fertiliser aerosols found in horticultural environments.
Its universal M10 interface accepts common fittings — bolts, threaded rod, eye bolts, turnbuckles and wire tensioners — enabling quick integration with greenhouse steelwork, gutter supports and service brackets. The rigid clamping face spreads load to reduce point stress on the wire, while the straight geometry helps maintain consistent tension and tidy wire runs during crop changes, screen adjustments and seasonal re-stringing. Suited to both new installations and retrofit upgrades.
Key features
- Straight / in-line pattern: maintains centreline for clean, repeatable wire runs across bays.
- M10 connection: compatible with eye bolts, threaded rod, turnbuckles and screen hardware.
- Hot-dip galvanised steel: thick zinc layer for long-term protection in humid greenhouse climates.
- Load distribution: rigid clamp face reduces localised stress on crop and trellis wires.
- Fast installation: bolt-on design for predictable fitting on trusses, purlins and service frames.
Typical greenhouse applications
- Trellis / crop support wires: tomatoes, cucumbers, peppers and vine crops along production rows.
- Climate screen and shade lines: secure, in-line fixing for screen cables and edge terminations.
- Stay and guide wires: bracing around gutters, end walls, doors and technical corridors.
Installation guidance
- Position on a clean, flat bearing surface; seat the wire centrally before tightening the M10 fixings.
- Use appropriate M10 hardware and washers; increase tension gradually and re-check after thermal cycles.
- Preserve the galvanised coating; avoid grinding/cutting in close proximity during assembly.
Maintenance
- Annual inspection: verify wire tension, check for abrasion and confirm fastener condition.
- Replace consumables (nuts/washers) when worn; the hot-dip galvanised body is built for long service life.
