Compact U-bolt clamp with M8 thread for securing exhaust sleeves, round tube and light ducting. The steel body has a durable
zinc-plated finish that provides everyday corrosion protection and a neat, low-profile hold on pipe joints and brackets. The
contoured saddle and bent U-bolt spread load evenly, helping to protect thin-wall tubing while keeping alignment tidy.
Ideal for on-vehicle repair, plant maintenance and general pipework. Installs quickly with two nuts and washers and can be
re-torqued during service checks. Interfaces cleanly with hanger straps, mounting plates and support frames wherever a compact,
in-line fixing is preferred.
Key features
- M8 U-bolt with matching saddle for reliable clamping on common pipe sizes.
- Zinc-plated steel for clean appearance and everyday corrosion resistance.
- Even load distribution minimises point stress on the pipe wall and joint sleeves.
- Low profile geometry fits tight spaces and short slip joints.
- Fast installation with two-nut tightening; easy re-torque after heat cycles.
Typical applications
- Joining and supporting exhaust pipes, sleeves and reducers.
- Fixing round tube and light ducting to straps, plates and frames.
- Temporary clamping for alignment, leak checks and repair work.
Installation guidance
- Seat the saddle over the joint, insert the U-bolt and fit washers and nuts.
- Tighten both sides alternately to compress the joint evenly; avoid over-torque on thin-wall tube.
- Re-check after the first heat cycle and re-torque if settling is observed.
Maintenance
- Periodically inspect for corrosion and thread wear; replace worn fasteners.
- If removed, clean threads and fit new nuts to maintain clamping performance.
