Reusable film clip for securing polyethylene greenhouse film, shade cloth and insect mesh to frames and hoops.
The formed steel body features an electrolytically zinc-plated finish for practical corrosion protection in covered
horticultural environments. A smooth contact area grips the cover without cutting or pinching, keeping sheets taut and
neatly aligned along trusses, purlins and perimeter tubes.
The snap-on design enables fast installation and repositioning during vent adjustments or cover changes. Use singly for
light duty or in pairs for higher wind loads and edge terminations. Compatible with typical round or box members used
in greenhouse and polytunnel construction; ideal for new builds and retrofit maintenance.
Key features
Electrolytically zinc-plated steel: clean, durable coating suited to indoor/covered zones.
Secure sheet retention: holds film and mesh tight without tearing the material.
Snap-on, reusable clip: quick to fit, remove and reposition during seasonal work.
Low profile: minimal projection into crop rows; tidy routing along frames.
Versatile use: film, shade nets, insect mesh and light membranes.
Greenhouse applications
Fixing and tensioning PE film on hoops, sidewalls and end frames.
Attaching shade cloth and insect screens to purlins and door frames.
Temporary clipping during cover replacement, patching and vent adjustments.
Installation guidance
Lay film smoothly; place the clip over the frame and press until it snaps in place.
Use additional clips at corners, seams and high-load edges; avoid over-stretching the film.
Keep sharp edges away from the cover; do not grind or cut near the installed clip.
Maintenance
Inspect periodically for coating wear and loss of spring; replace deformed clips.
Clean contact surfaces to remove grit that could abrade the film.
