Cold-formed omega clamp made from 40×2 mm steel strip with a continuous sendzimir galvanised coating. Designed for greenhouse structures, it provides a neat, secure wrap around tubes, brackets and profiles to anchor crop-support lines, light services and auxiliaries without bulky fixtures. The smooth zinc layer resists humidity, condensation and fertiliser aerosols typical of horticulture.
The compact omega geometry delivers high clamping force with even load distribution along the strap, helping protect tubes and wires from point stress. Pre-drilled holes simplify bolt-up with standard M-hardware and washers, enabling fast, repeatable installs on trusses, purlins, gutter supports and service frames—ideal for new builds and retrofit upgrades.
Key features
- 40×2 mm steel strap: robust section for reliable clamping in greenhouse environments.
- Sendzimir galvanised: uniform zinc coating for long-term corrosion resistance.
- Omega profile: self-centring wrap improves alignment and contact area on round/box members.
- Clean installation: pre-drilled for bolt-on assembly; minimal protrusion along crop rows.
- Low maintenance: durable finish reduces touch-ups and supports long service intervals.
Greenhouse applications
- Fixing trellis and crop-support wires to trusses, purlins and perimeter steel.
- Securing climate-screen cords, light conduits and small service brackets.
- Tie-backs, stays and guide lines around gutters, end walls and doors.
Installation guidance
- Place the clamp centred on the member; add suitable washers and tighten evenly.
- Avoid over-tensioning on thin-wall tubes; increase torque gradually and re-check after thermal cycles.
- Preserve the zinc layer—do not grind or cut near the clamp during assembly.
Maintenance
- Annual inspection for coating integrity and fastener condition; re-torque if required.
- Replace consumables (nuts/washers) as needed; the sendzimir finish is designed for long service life.
