Long-oval brace bracket with strap formed from 35×4 mm press metal for accurate diagonal bracing in greenhouse frames.
The extended oval slot gives generous adjustment to set brace angle and tension precisely, while the included flat strap
provides a clean tie between round or box members. The hot-dip galvanised coating (thick zinc layer) delivers robust
corrosion protection in humid, fertiliser-laden environments.
The 35×4 mm section offers a stiff, low-profile bearing that spreads load over a wide contact area, reducing point stress and
preserving coatings on tubes and profiles. Designed for quick assembly with common fasteners and washers, suitable for new build
and retrofit work where reliable, rattle-free bracing is required.
Key features
- 35×4 mm press metal: stable, rigid bracket body with broad load spread.
- Long adjustable slot: extended travel for fast, precise alignment and brace tensioning.
- Supplied strap: neat connection between posts, purlins and perimeter members.
- Hot-dip galvanised: durable, thick zinc coating for long service in greenhouse climates.
- Low profile: tidy installation with minimal projection into crop aisles.
Typical applications
- Diagonal tube braces between posts and purlins.
- Stay/guide connections on end walls, doors and gutter lines.
- Stiffening of frames and service structures with compact strap ties.
Installation guidance
- Seat on a clean bearing face; align through the long slot and tighten fixings evenly with suitable washers.
- Set strap length and tension progressively; re-check after initial load and thermal cycles.
- Protect the HDG coating; avoid cutting/grinding near the joint during assembly.
Maintenance
- Annual inspection of fasteners, strap condition and brace tension; re-torque if required.
- Replace worn nuts/washers; keep contact faces clean to minimise abrasion.
