Wide-oval brace bracket formed from 40×2 mm pressed steel strip for precise lateral alignment and secure fixing of diagonal braces in greenhouse frames. The extra-wide slot offers generous side-to-side tolerance, enabling quick, tidy positioning across trusses, purlins and perimeter members with a low-profile installation along crop rows.
Manufactured as press metal from a consistent 40×2 mm section, the bracket spreads load over a broad contact area to reduce point stress and protect coatings. Available finishes: Sendzimir galvanised for uniform corrosion protection, or black/untreated steel for projects that will be painted or coated on site.
Key features
- 40×2 mm pressed steel: stable geometry with good load spread.
- Wide oval slot: ample lateral adjustment for fast, accurate brace alignment.
- Low profile: neat fit with minimal projection into working aisles.
- Two finishes: Sendzimir galvanised or black/untreated steel (for post-finishing).
- Greenhouse use: trusses, purlins, door/end frames and gutter supports.
Installation guidance
- Seat on a clean bearing face; use the wide slot to centre the brace and tighten fixings evenly.
- Protect edges and coatings; avoid grinding/cutting in close proximity.
- Re-check brace tension after initial load or thermal cycles.
